Soccer: 1, 2, 3 Pass and Move

Set up as shown with 2 cones (the disatance of which between can be modified depending on ability or challenge you want to set your players).

1 player on each cone and 1 player in the middle, 1 ball between the 3.

Players always take 2 touches, the ball is moved from one end, into the middle man and then to the other end before the sequence is repeated from the other side.

Set up as shown.

Player 1 starts with the ball in the middle of the field and plays a 1-2 pass with player 2 before passing out wide to player 3.

At this point, players 1 and 2 run towards the penalty area, ready to receive a cross, while one of the defenders goes out wide to put pressure on the crosser.

Player 3 will cross the ball into the box where players 1 and 2 will try to beat the defender to it and score.

Encouraging 1st time shooting by using the correct technique to take the shot early and finish from close range.

Get your knee over the ball and use the pace of the ball to generate the power. By trying to strike the ball too hard, the likelihoood is the accuracy will be poor.

Blue 1 plays ball into area and clue 2 moves in to shoot 1st time. Blue 2 goes to replace blue 1 and blue 1 runs around working area to take blue 2s place.

Players pass and then move to find an empty cone. Players should take 1 touch.

With bigger numbers in your training session you can increase the number of cones and the number of balls accordingly.